Pipe Ref
Units

Calculation verification

Every result on this page can be checked by hand. For each calculator: the inputs, the formula, a worked example with real numbers, the units, the standard it comes from, and what it does not cover. Worked examples checked against the calculator output on 17 Nov 2026.

Pipe cut lengthASME B16.9, B16.11 and B16.5 fitting dimensions

Input parameters

ParameterSymbolUnitSource
Pipe sizeNPS–Isometric
Dimension on the isometricLmm or inCentre to centre; to flange face for weld neck flanges
Fitting at each end––Isometric / BOM
Butt weld root gapgmmWelding procedure (WPS), often 1.6–3 mm
Socket gapsmmASME B31.3 / B16.11 practice, about 1.6 mm
Flange class or SW fitting class––Piping class
Extra length for field fitemmFabrication note (e.g. FFW +100)

Formula used

Cut length  = L − T_A − T_B − g × (number of butt welds) + e
Butt-weld elbow or tee: T = centre-to-end (B16.9: A for 90°, B for 45°, C for tee)
Weld neck flange: T = Y, length through hub to the raised face (Class 400 and above: Y + 6.4 mm raised face)
Socket weld fitting: T = A (centre to socket bottom, B16.11) + socket gap s; no root gap
Plain end: T = 0, no weld

Worked example

NPS 6 piece between two 90° LR elbows, 2000 mm centre to centre, root gap 3 mm. Second case: NPS 6 from a 90° LR elbow to a Class 300 weld neck flange face, 1200 mm.

  1. B16.9 NPS 6 90° LR: A = 9.00 in = 228.6 mm
  2. Cut = 2000 − 228.6 − 228.6 − 2 × 3 = 1536.8 mm (60 1/2 in)
  3. B16.5 Class 300 NPS 6 weld neck: Y = 3.88 in = 98.6 mm (includes 1.6 mm raised face)
  4. Cut = 1200 − 228.6 − 98.6 − 2 × 3 = 866.8 mm

Result: 1536.8 mm between two elbows; 866.8 mm from elbow to flange face.

Units

  • mm, with inches to the nearest 1/16 in

Standard or engineering basis

  • ASME B16.9 centre-to-end dimensions
  • ASME B16.11 socket weld fitting dimensions (Class 3000 / 6000)
  • ASME B16.5 weld neck length through hub

Assumptions and limitations

  • Weld shrinkage is not included; some fabricators add 1–2 mm per weld.
  • Reducing tees, reducers, olets, valves and special fittings: enter their take-out with the "Other" option from the vendor or standard.
  • Dimensions on the isometric to the face of a mating flange do not include the gasket; check how your isometrics are dimensioned.
  • Always confirm against the actual fittings received: mill and forging tolerances apply.