Pipe Ref
Units

Shoe support: approx. spool length PRELIMINARY

Approximate straight spool length needed to fit a pipe shoe while keeping the shoe attachment weld clear of butt welds and leaving room to withdraw the flange stud bolts. Two spool cases: flanged both ends, or flanged one end and butt-welded the other.

Calculation verification

Every result on this page can be checked by hand. For each calculator: the inputs, the formula, a worked example with real numbers, the units, the standard it comes from, and what it does not cover. Worked examples checked against the calculator output on 17 Nov 2026.

Shoe spool lengthB16.5 weld neck dimensions and stud build-up

Input parameters

ParameterSymbolUnitSource
NPS and class→ tf, Y, d, nmmASME B16.5 weld neck RF flange
Shoe lengthLsmmPipe support standard
Spool case––Flange × flange, or flange × weld
Weld clearanceCwmmProject rule (50 mm default)
Bolt handling allowanceCbmmProject rule (25 mm default)
Gasket thicknesstgmmGasket standard
Stud length override–mmOptional
Field-weld allowanceFAmmCase 2 field weld (100 mm default)

Formula used

tf′ = tf + RF;  Y′ = Y + RF   (RF = 6.4 mm for Class 400 and up, else 0)
Stud = 2·tf + 2·RF + tg + 2·d + 2·3·p, rounded up to 5 mm
Clearance A = max( tf′ + stud + Cb ,  Y′ + Cw )
Case 1 (flange × flange):  L = A + Ls + A
Case 2 (flange × weld):    L = A + Ls + Cw (+ FA if field weld)
Shoe CL from RF face = A + Ls/2;  pipe cut length = L − 2Y (case 1)

Worked example

NPS 6 Class 300, shoe 300 mm, case 1 (flange × flange), Cw 50, Cb 25, gasket 4.5 mm, round up to 10 mm.

  1. B16.5: tf = 1.38 in = 35.1 mm; Y = 3.88 in = 98.6 mm; 12 × 3/4″ studs, p = 2.54 mm
  2. Stud = 2 × 35.1 + 4.5 + 2 × 19.05 + 6 × 2.54 = 127.9 → 130 mm
  3. Bolt removal = 35.1 + 130 + 25 = 190.1 mm; weld clearance = 98.6 + 50 = 148.6 mm → A = 190.1 mm
  4. L = 190.1 + 300 + 190.1 = 680.1 mm → 690 mm
  5. Shoe CL = 190.1 + 150 = 340 mm; pipe cut = 690 − 2 × 98.6 = 493 mm

Result: About 690 mm RF face to RF face (preliminary).

Units

  • mm, with inch equivalents

Standard or engineering basis

  • ASME B16.5 weld neck flange thickness and hub length
  • Stud build-up as in the Bolt length calculator

Assumptions and limitations

  • Preliminary layout estimate, not a guaranteed minimum.
  • Studs are withdrawn towards the spool side.
  • Weld clearance, bolt handling and field-weld allowances are typical defaults, not code values.
  • Slip-on, lap-joint, RTJ and vendor flanges differ from B16.5 weld neck RF values.
  • The pipe support standard, weld procedure and piping class govern.