Pipe Ref
Units

Pipe spacing

Minimum centre-to-centre distance between two parallel lines on a rack or in a trench, using pipe OD, ASME B16.5 flange OD and insulation thickness. Flanges are assumed not staggered, so a flange on one line sits next to the plain or insulated pipe of the other.

Calculation verification

Every result on this page can be checked by hand. For each calculator: the inputs, the formula, a worked example with real numbers, the units, the standard it comes from, and what it does not cover. Worked examples checked against the calculator output on 17 Nov 2026.

Pipe spacingPipe OD and B16.5 flange OD

Input parameters

ParameterSymbolUnitSource
Line A and B: NPS→ ODmmASME B36.10M
Line A and B: flange class→ FmmASME B16.5 flange OD
InsulationinsmmInsulation specification
Pipe gapgmmProject standard (25 mm typical)
Flange gapgfmmProject standard (25 mm typical)
Flanges–with / withoutLayout
Rounding–mmRack module

Formula used

Pipe or insulation:  OD_A/2 + ins_A + OD_B/2 + ins_B + g
Flange A to line B:  F_A/2 + OD_B/2 + ins_B + gf
Flange B to line A:  F_B/2 + OD_A/2 + ins_A + gf
C–C = largest of the three, rounded up
Flanges side by side (not recommended):  F_A/2 + F_B/2 + gf

Worked example

Line A: NPS 6 Class 300, 50 mm insulation. Line B: NPS 4 Class 150, bare. Gaps 25 mm, round up to 5 mm.

  1. OD_A = 168.3; F_A = 317.5; OD_B = 114.3; F_B = 228.6 mm
  2. Pipe or insulation: 84.1 + 50 + 57.2 + 0 + 25 = 216.3 mm
  3. Flange A to line B: 158.8 + 57.2 + 0 + 25 = 240.9 mm
  4. Flange B to insulated line A: 114.3 + 84.1 + 50 + 25 = 273.4 mm (governs)
  5. Rounded up to 5 mm: 275 mm

Result: 275 mm C–C (exact 273.4 mm).

Units

  • mm or inch, following the site unit setting

Standard or engineering basis

  • Pipe OD: ASME B36.10M
  • Flange OD: ASME B16.5

Assumptions and limitations

  • Flanges on adjacent lines are staggered.
  • Flanges are taken as bare; add the box size for insulated flanges.
  • Shoes, guides, thermal movement and future lines are not included.
  • NPS 26 and above (B16.47) are not included.