Gate valve vs globe valve: what is the difference?
Both are linear valves with a handwheel and a rising stem, and on a drawing they look almost the same. Inside they work very differently, and that decides where each one belongs.
How a gate valve works
A gate valve has a wedge (the gate) that slides across the flow path. Fully open, the gate lifts clear of the bore, so the fluid goes straight through with almost no pressure loss. Fully closed, the wedge presses against two seats.
It is an isolation valve: it should be either fully open or fully closed. Part open, the fluid rushes through the small gap under the gate, which vibrates the wedge and wears the seats (wire drawing). It also takes many turns to open, so it is slow.
How a globe valve works
A globe valve has a disc that moves straight towards or away from a round seat. The flow has to turn up through the seat and back down again, in an S-shaped path. That costs pressure, but it makes the valve good at regulating flow: a small movement of the disc changes the flow steadily, and the seat wears evenly.
Globe valves also shut off well and need fewer turns than a gate valve of the same size. Y-pattern bodies reduce the pressure loss; angle bodies save an elbow.
Side by side
| Gate valve | Globe valve | |
|---|---|---|
| Main job | Isolation, fully open or shut | Throttling and regulating |
| Pressure loss when open | Very low, straight-through bore | High, flow changes direction |
| Throttling | No: seats and wedge wear | Yes |
| Flow direction | Either way | Arrow on the body |
| Operation | Many turns, slow | Shorter stroke |
| Face to face | ASME B16.10 | ASME B16.10 |
| Common steel valve standard | API 600 (API 602 for small forged) | API 623 (API 602 for small forged) |
| P&ID symbol | Two triangles point to point | The same, with a filled dot in the middle |
Where each one goes
- Gate: isolation at pumps, exchangers and vessels, battery limits, and anywhere a low pressure loss matters.
- Globe: the bypass around a control valve, manual flow control, fine adjustment on small lines, and vents and drains that are opened gradually.
In many plants, ball and butterfly valves now take over part of the isolation duty, especially in smaller sizes and quarter-turn service. Your piping class lists which valve type to use for each size and service.
Common questions
Can a gate valve be used for throttling?
No. Part open, the flow erodes the seats and wedge and makes the gate vibrate. Use a globe valve, or a control valve, to regulate flow.
Why is a globe valve used on a control valve bypass?
The bypass is used to control the flow by hand while the control valve is out of service, and a globe valve can throttle smoothly without damage.
Which way does the flow go through a globe valve?
Follow the arrow on the body. Most globe valves are installed with the flow coming up under the disc, so the packing is not under pressure when the valve is shut.
More guides
General engineering guidance for learning and early design. Your project specifications and the governing code edition always take precedence.