Pipe Ref
Units

What is a trunnion support?

A trunnion is a short piece of pipe welded to a process line so that the line can sit on a support. It turns an awkward support point, like an elbow or a pipe high above the steel, into a simple rest.

The two types

  • Elbow trunnion (dummy leg). Welded to the back of an elbow, usually at the bottom of a riser. The trunnion points down to the steel or a base plate and carries the weight of the vertical run above it.
  • Straight pipe trunnion. Welded square onto a straight run, so the line can rest on steel that is some distance away, or so that it clears insulation or another line.

You can turn both types in 3D on the Pipe supports page.

When to use one

  • At the bottom elbow of a riser, so the weight goes down to the ground and not into a nozzle.
  • Where a line must sit higher than the steel below it, for example to clear a flange or another line.
  • On large or insulated lines where a shoe alone is not enough.

How it is sized

The trunnion is normally one or two sizes smaller than the line it carries, picked from the project's support standard. Its length is set by the distance to the steel. Then three things are checked:

  1. The trunnion as a column or cantilever, carrying the vertical and sideways loads.
  2. Local stress in the line where the trunnion is welded on. This is usually the limit. Stress engineers check it with methods such as WRC 107 or WRC 297, or with finite element analysis, and add a reinforcing pad if it is too high.
  3. The weld between trunnion and line.

Details that are easy to miss

  • Drill a small vent hole in a closed trunnion so trapped air or water can escape during welding, heat treatment and testing.
  • The trunnion is a pressure-part attachment: it must be a material compatible with the line, and welded by a qualified procedure.
  • On hot lines the trunnion grows with the pipe. Let it slide on its base plate, or use a guide, as the stress analysis decides.
  • Insulation must be finished around the trunnion so water cannot get in.

Common questions

What is the difference between a trunnion and a dummy leg?

They are the same idea. "Dummy leg" usually means a trunnion welded to an elbow; "trunnion" is the general term and also covers a stub on straight pipe.

Why does a trunnion need a vent hole?

A closed trunnion traps air. When it is welded, heat treated or the line is tested, that air expands or water gets in. A small hole lets it escape.

What limits the size of a trunnion?

Usually the local stress in the pipe wall where the trunnion is welded on, not the trunnion itself. A reinforcing pad or a larger trunnion spreads the load.

More guides

General engineering guidance for learning and early design. Your project specifications and the governing code edition always take precedence.