RF vs RTJ flange faces
The face of a flange decides which gasket it takes. Raised face is the everyday choice; ring type joint is for high pressure and temperature.
Raised face (RF)
The sealing area is a ring that stands up from the rest of the flange face, so the bolt load is concentrated on the gasket. In ASME B16.5 the raised face is 1.6 mm (1/16 in) high for Class 150 and 300, and 6.4 mm (1/4 in) for Class 400 and above. It takes flat gaskets such as spiral wound, kammprofile or sheet.
Ring type joint (RTJ)
Each flange has a machined groove, and a solid metal ring sits in the two grooves. Bolting squeezes the ring so it seals metal to metal. Rings are oval or octagonal (type R), or pressure-energised (RX, and BX for API 6A).
- The ring must be softer than the groove, so the ring deforms and not the flange.
- The flanges stay apart by a set gap, so the bolts and spacing differ from RF.
- To change a ring, the flanges must be spread apart; plan for it at the layout stage.
Side by side
| RF | RTJ | |
|---|---|---|
| Gasket | Spiral wound, kammprofile, sheet | Solid metal ring (R, RX, BX) |
| Typical classes | 150 to 2500 | Mostly 600 and above |
| Service | Most process and utility lines | High pressure and temperature, hydrogen, wellhead |
| Assembly | Simple | Needs clean grooves, the right ring, and room to spread the flanges |
| Cost | Lower | Higher |
Common questions
Can an RF flange be bolted to an RTJ flange?
No. The faces are different; use matching flanges, or a special transition piece.
Why must the ring be softer than the groove?
The ring has to deform to seal. If it were harder, it would dent the groove and spoil the flange.
Is the raised face included in the B16.5 flange thickness?
For Class 150 and 300 the 1.6 mm raised face is included in the listed thickness; for Class 400 and above the 6.4 mm face is added to it. Check the table notes of your edition.
More guides
General engineering guidance for learning and early design. Your project specifications and the governing code edition always take precedence.