Pipe Ref
Units

Long radius vs short radius elbow

Long radius elbows are the default in process piping. Short radius elbows save space, at a cost in pressure drop and stress.

The dimensions

ASME B16.9 sets the bend radius from the size. For a long radius (LR) 90° elbow, the centre-to-end dimension is 1.5 × the nominal size in inches; for a short radius (SR) elbow it is 1.0 ×.

SizeLR 90° centre to endSR 90° centre to end
NPS 4152.4 mm (6 in)101.6 mm (4 in)
NPS 6228.6 mm (9 in)152.4 mm (6 in)
NPS 12457.2 mm (18 in)304.8 mm (12 in)

Why LR is the default

  • Lower pressure drop: the gentler turn loses less energy.
  • Lower stress: a tighter bend has a higher stress intensification factor, which matters in thermal and cyclic loading.
  • Easier pigging and cleaning, and less erosion in slurries and two-phase flow.

When SR is used

Where space is tight: at a pump or compressor nozzle, inside a crowded skid, or to keep a line close to steel. Many piping classes only allow SR elbows with approval, and some reduce their pressure rating, so check your class before using one.

3D and 5D bends

For pigged lines, slurries and some high-velocity services, bends with a radius of 3 or 5 times the diameter are used. They are usually made by bending pipe rather than as forged fittings.

Common questions

How do I work out an LR elbow dimension?

Multiply the nominal size in inches by 1.5 to get the 90° centre-to-end in inches (for NPS ¾ and above). For NPS 6: 1.5 × 6 = 9 in, 228.6 mm.

Can I cut an elbow to make a 60° bend?

Yes. The centre-to-end of a cut elbow is R × tan(θ/2). The elbow take-off calculator does it for any angle.

Are short radius elbows weaker?

They see higher stress for the same load because of the tighter bend, and some specifications reduce their rating. Use them only where your piping class allows.

More guides

General engineering guidance for learning and early design. Your project specifications and the governing code edition always take precedence.