Pipe Ref
Units

Pipe shoe, guide, line stop and anchor: what each one does

Every pipe support is defined by which directions it stops the pipe moving. Learn the four basic ones and most support drawings start to make sense.

Think in directions

A pipe can move up and down, sideways, and along its own axis, and it can rotate. Each support blocks some of those movements and lets the others happen.

SupportStopsLets the pipeUsed for
Rest / shoeDownward movement (carries weight)Slide along and sideways, liftMost supports on a rack
GuideDown and sidewaysSlide along its axisKeeping a line straight, near loops
Line stopDown and along the axisMove sidewaysSplitting growth, protecting nozzles
AnchorAll directions and rotationNothingFixed points between loops

The shoe

A shoe is a T-section welded or clamped under the pipe. It lifts insulated pipe clear of the steel, so the insulation is not crushed, and it gives a flat surface to slide on. A guide or stop is often built around the same shoe.

How they work together

On a hot rack line, the line rests on every beam, is guided every few beams and on both sides of a loop, and is anchored between loops so each loop takes its own share of growth. Around equipment the order flips: the aim is to keep loads off nozzles, so adjustable supports and springs appear near the nozzle and rigid restraints further away.

Shear lugs: how stops and anchors grip the pipe

A guide or rest only needs the pipe to sit in it, but a line stop or an anchor has to push on the pipe. The usual way is a pair of shear lugs: small plates welded to the pipe (or to its shoe) that bear against the support steel, one each side, so the pipe cannot slide along its axis.

  • Lugs welded straight onto the pipe are pressure-part attachments: use a compatible material and a qualified weld, and have the local stress checked on thin or hot lines.
  • Leave a small gap between lug and steel if the stress analysis allows some movement, or none for a true stop.
  • On pipe that should not be welded (some alloys, lined or galvanised pipe), use a clamp with lugs instead.

Springs and hangers

Where the pipe moves up and down, a rigid rest would lift off. Variable or constant springs carry the weight while letting the pipe move.

Common questions

What is the difference between a guide and a line stop?

A guide stops sideways movement but lets the pipe slide along its axis. A line stop does the opposite: it stops axial movement and allows sideways movement.

Why use a shoe instead of resting the pipe on the steel?

On insulated lines the shoe keeps the insulation off the steel. It also gives a defined sliding surface and a place to fix guides and stops.

Where should anchors go?

At fixed points that split a long hot line into sections, typically between two loops, and where the stress analysis needs them.

What is a shear lug on a pipe support?

A small plate welded to the pipe or its shoe that bears against the support steel. A pair of them turns a rest into a line stop or part of an anchor by stopping the pipe sliding along its axis.

More guides

General engineering guidance for learning and early design. Your project specifications and the governing code edition always take precedence.