How to calculate pipe cut length from an isometric
An isometric gives centre-to-centre or centre-to-face dimensions. The pipe you cut is shorter: you take off what each fitting adds, and the gap for each weld.
The rule
Cut length = isometric dimension − take-out at end A − take-out at end B − root gap × butt welds (+ any field extra)
Take-outs for common fittings
| Fitting at the end | Take-out | Example, NPS 6 |
|---|---|---|
| 90° LR elbow (B16.9) | Centre to end, A = 1.5 × NPS in | 228.6 mm |
| 45° LR elbow (B16.9) | Centre to end, B | 95.3 mm |
| Tee (B16.9) | Centre to end, C | 142.9 mm |
| Weld neck flange (B16.5) | Length through hub to the face, Y | 98.6 mm (Class 300) |
| Socket weld fitting (B16.11) | Centre to socket bottom, plus the 1.6 mm gap left at the bottom | Depends on class |
Worked example
NPS 6, between two 90° LR elbows, 2000 mm centre to centre, root gap 3 mm:
2000 − 228.6 − 228.6 − 2 × 3 = 1536.8 mm
NPS 6, from a 90° LR elbow to the face of a Class 300 weld neck flange, 1200 mm:
1200 − 228.6 − 98.6 − 2 × 3 = 866.8 mm
Mistakes to avoid
- Forgetting the gaps: every butt weld needs its root gap; socket welds need the 1.6 mm gap at the bottom of the socket instead.
- The raised face: for Class 400 and above, the B16.5 Y dimension does not include the 6.4 mm raised face; add it if your isometric dimensions to the face.
- Gaskets: dimensions to a mating flange face do not include the gasket; check how your isometrics are dimensioned.
- Field welds: leave extra length (often 100 mm) on pieces marked FFW, to be cut to fit on site.
- Shrinkage: some fabricators add 1–2 mm per weld.
Common questions
What is a take-out in piping?
The length a fitting adds between the point the isometric measures to and the end of the pipe, for example the centre-to-end of an elbow.
How much root gap do I allow?
The welding procedure sets it; 1.6 to 3 mm is common for butt welds.
Do socket weld joints need a gap?
Yes. The pipe is pulled back about 1.6 mm from the bottom of the socket before welding, so the weld does not crack as it cools.
More guides
General engineering guidance for learning and early design. Your project specifications and the governing code edition always take precedence.