Pipe Ref
Units

Sizing an expansion loop with the guided cantilever method

A hot pipe grows. If nothing gives, that growth pushes on anchors and nozzles. A loop or a bend gives the pipe somewhere to flex. The guided cantilever method sizes it in a minute.

How much does a pipe grow?

Growth is ΔL = α × L × ΔT. For carbon steel, α is roughly 12 × 10⁻⁶ per °C at moderate temperatures, which is about 1.2 mm per metre for every 100 °C. ASME B31.3 Appendix C lists the total expansion per metre for each material and temperature, which is the better number to use.

The guided cantilever idea

Picture the leg of a loop as a beam fixed at one end and guided at the other, so both ends stay parallel while one end is pushed sideways by the growth Δ. The bending stress in that leg is:

σ = 3 E D Δ / L²     so     L = √(3 E D Δ / S_A)

E is the elastic modulus, D the pipe OD, and SA the allowable displacement stress range from B31.3 302.3.5. A bigger pipe or more growth needs a longer leg.

From leg to loop

  • In a symmetric loop, each pair of legs takes its share of the growth coming from each side.
  • Put the loop in the middle between two anchors, so each side grows into it equally.
  • Guide the line on each side of the loop, a few supports away, so it grows into the loop and not sideways.
  • Nest loops on a rack with the hottest or largest outermost.

Limits

The method ignores elbow flexibility and rotation, so it is usually conservative for the size, but it can under-predict anchor forces. It is for early layout and space reservation. The stress analysis confirms the final loop, and high temperatures, large sizes, equipment nozzles and non-metallic pipe always need it.

Common questions

Where should an expansion loop go?

Midway between two anchors, so the growth from each side is equal, usually at a rack bay kept free for loops.

Why guide the pipe near a loop?

Guides keep the line moving along its axis into the loop. Without them the line can bow sideways and walk off its supports.

Is the guided cantilever method enough on its own?

For early sizing, yes. The final design comes from a pipe stress analysis, especially for hot lines, large sizes and lines near equipment.

More guides

General engineering guidance for learning and early design. Your project specifications and the governing code edition always take precedence.